Installation and maintenance of linear vibrating screen
Date:2017-02-14 Source:zk corp Views:
Linear vibrating screen is based on the production needs of our country, in the digestion absorption from the outside on the basis of foreign vibrating screen, summed up the ZK Corp for many years of research design and use of the test, combined with China's national conditions developed a new series of vibrating screen. Through years of production practice, that the series of sieve machine with a large amount of processing, technical parameters reasonable, structural strength, high rigidity, serialization, generalization, high degree of standardization. Smooth and reliable operation, low noise, easy maintenance and maintenance and a series of advantages.
Linear vibrating screen installation and commissioning:
1. The machine placed in a solid level of solid ground (concrete or steel floor), through the anchor bolts (base bolt user-owned), fastening.
2. The spring set in the upper and lower seat (placed sieve), the spring should be fully into the spring seat, to ensure that the vertical, not twisted crooked.
3. The vibration part of the screen machine shall not be any other objects with the machine outside the hard connection or contact.
4. Connected to power, press the start button (the machine can be directly activated), so that the vibration motor synchronous reverse rotation.
5.The excitation force adjustment: the vibration of the motor at both ends of the eccentric block can be adjusted to adjust the angle of the two eccentric body can change the size of its exciting service, sieve machine factory ex-excitation force has been transferred to the best state, can be Directly into use, no need to make adjustments.
6.If necessary, can be adjusted as follows: open the motor at both ends of the protective cover, loosen the eccentric block of the tightening bolts, the two ends of the adjustable eccentric block for the same direction of rotation, so that the value on the bit Engraved lines, this time is the required exciting force. Adjustment is completed, the tightening bolts tighten.
7.Such sieve machine open, stop through its vibration area will have a more substantial vibration, in order to improve this situation, can be equipped with electrical brake device.
Use of linear shaker for maintenance
1. The sieve machine operation, the vibration part of the object should not be connected with any object or contact. (Soft connection must be used under the guidance of the manufacturer)
2. The material feed, the feed should be in the width of the entire width of the width of the feed to ensure uniform distribution of materials on the screen surface.
3. The material falling, no major impact, so as not to damage the screen.
4. Open, before the shutdown, the screen surface may not have retained material.
5. The equipment running if abnormal sound, should immediately shut down the check, troubleshooting can start after the boot.
6. The maintenance of vibration motor see its instructions.
- Next Page: Key Points of Selecting Bag Filter
- Previous: The importance of rotary kiln sealing device