Precautions of the Usage Process of Lime Rotary Kiln

In the daily usage of lime rotary kiln equipment to pay attention to the following factors, so that the lime kiln to reduce the frequency of failure and improve equipment production efficiency.
1. Keep the lime rotary kiln routine inspection. To conduct a comprehensive weekly inspection. Check the contents include: fastening, bearing seal, counterattack liner, liner wear and so on.
2. Adjust the lime rotary kiln rotor and counterattack liner. When the device is running, the gap between the rotor and the backing plate cannot be adjusted. Therefore, the required density of more than 2.50g / cm3; water absorption of less than 1.0%; dry compressive strength greater than 60.0MPa; flexural strength greater than 8.0MPa.
3. Lime rotary kiln shutdown sequence and the boot sequence. In equipment work, the feed pellets should be strictly in accordance with the provisions of the prohibition of the material is greater than the provisions of the kiln, otherwise it will cause impeller imbalance and wear and tear, base to plug the impeller channel and the center of the feed tube, the lime rotary kiln system does not work, in addition, if found to be large pieces of material should be promptly excluded.
4. Replacement of lime kiln wear parts. When replacing consumables, first open the shelf. Remove the connecting bolt from the upper case and the middle case, and use a wrench to screw it into the clamshell hexagonal head, and then open it again. At the same time, you can also use the hanging device above the rack to lift the rear frame, and then repeat the above process, after closing the shelves.
5. Lime rotary kiln hammer if worn to a certain extent, should be promptly adjusted or replaced, otherwise it will lead to the fastener and other parts of the injury.