New Type Slag Rotary Kiln

Compared with the traditional rotary kiln, the new type slag rotary kiln is an important improvement in the design and structure of the part, through a lot of data analysis and practical effect test, application, proved that the new rotary kiln equipment drying effect is quite good, energy saving and drying effect greatly improved, and a significant technological progress. Slag, iron slag, mineral powder rotary kiln, from the overall consideration, the overall start, in order to achieve better results. We are here to introduce important improvements and designs made to other parts of the rotary kiln.
In the rotary kiln structure and function has made a significant improvement, the usage of transmission gear mosaic structure: with the traditional rotary kiln transmission spring steel can be compared with the gear structure, rotary kiln cylinder after processing, gear mounted on the cylinder, concentricity more high, the dryer stiffness is better, the operation is more stable, the vibration is small, the large rotary kiln must adopt the structure.
Rotary kiln feed in the front of the rotary kiln: the traditional rotary kiln feed is in the upper part of the boiling furnace, through the heat off the tube feed, because the rotary kiln boiling furnace temperature is very high, even the heat-resistant steel casting pipe is also very easy to burn out, frequent replacement, seriously affecting the normal operation of rotary kiln. In the front of the rotary kiln through a special device feed, you cannot under the tube, there is no material under the tube replacement. At the same time, cancel the feed tube, rotary kiln ventilation more smooth, better drying effect.
The usage of speed motor: In order to meet the different requirements of different materials on the rotary kiln speed, in the case of conditions permit, the appropriate increase in the speed of rotary kiln, rotary kiln height increased, you can better sprinkle the material, drying better. The Rotary kilns are generally used in the new combination of Yang plate and the center of the X-shaped plate, according to the nature of dry materials and specific conditions, the design of appropriate Yang device and determine the appropriate shape and layout, to ensure that the rotary kiln material hot air heat exchange.
For specific, specific rotary kiln operating system, to ensure effective drying time at the same time, to take shortening the residence time of rotary kiln measures to improve the capacity of rotary kiln to create the conditions. At present, most of the domestic rotary kiln internal Yang device devices are taken to take ordinary curved plate, this kind of lifting plate with a simple structure and strong adaptability to the material and so on. However, the rotary kiln yarn material dispersion is low, uniformity is poor, cannot form the ideal material screen.
The new type of composite type plate rotary kiln, the angle of the material is large, the material is throwing good, according to the material in the rotary kiln different drying area, combined with the actual production combination of a new type of lifting plate structure, through reasonable adjustment The material in the rotary kiln residence time, to achieve the material in the rotary kiln to accelerate the drying, constant drying and drying stage, a substantial increase in water evaporation rate and intensity, is the rotary kiln to increase production of key measures.