Attentions to Operate Diatomite Rotary Kiln---ZK Corp Would Guide You

Diatomite rotary kiln is the key equipment in industrial plant which are four important engineering projects of our company. How to operate diatomite rotary kiln correctly? Here today Zk corp (henan zhengzhou mining machinery co.,ltd) would give you the following suggestions;
1.Please fasten all the bolts, check the lubrication parts to guarantee sufficient oil and the cooling water pipe is unblocked.
2. Idle running motor for 2 hours and reducer for 8 hours before trial run. To record electricity,rising temperature and abnormal sound.
3.Idle running the drum for 2 days before bricklaying. Check the lubrication parts,temperature rising less than 30℃，the vibration of the transmission part, the contact of the gear and pinion and the sealing condition of kiln inlet and outlet.
4.Rotate the rotary kiln when the refractory brick flush. When the temperature in kiln is sufficient to burn coal powder, start blow coal powder and air. When it doesn’t burn,don’t allow person to stand in the kiln head or watch inside. When it burns the coal powder, the kiln should rotate slowly. After the temperature and feeding amount increasing,the rotation speed of kiln would increase.
5.All transmission parts and thrust roller should be checked frequently. Please handle in time if there is noise,vibration or heat rising.
6. Check and guarantee the kiln inlet and outlet sealing device are in good sealing condition.
7.After running 100-500 hours constantly, all the lubrication oil and grease should be replaced one time. After that,replace one time every six months.
8. When the rotary kin stop running,within 10 minutes,please stop feeding material and fuel,but don’t stop blower. After 10 minutes,please stop blower and flue gate. To avoid the rotary kiln body curve,please reduce the rotation speed gradually-1/4 rotation per 5-10 minutes,after two hours 1/4 rotation per 15-20 minutes, after 3 hours 1/4 rotation per 30 minutes and then 1/4 rotation per hour.
9.If stop the rotary kiln for a long period,please burn the kiln coating and ring forming.Pull the burner out of the kiln after stop feeding fuel. And all the material in the kiln should be unloaded. Stop air exhaust after the kiln cool completely.
After stop the kiln, please check whether the lubrication parts need supplement. All parts cooling water must be eliminated completely.These are the basic requirement of operating the rotary kiln. If you have other question, let’s discuss further.
We are expert of diatomite rotary kiln From equipment selecting, calcining and material requirement,capacity to installation and using, we would give you professional advice to guarantee your investment are feasible and profitable. And we would solve all the problems during installation and machine using. We are experienced and have strength technical strength. ‘Morality goes before work,profit got later than others’ is the core culture philosophy of ZK. ’Top quality service’ is our permanent pursuit. For any question or requirement, please feel free to contact us at 0086 371 55902853, We would serve for you sincerely.