Daily Maintenance and Repair of Quicklime Dust Collector

Date:2016-09-06 Source:zk corp Views:

Quicklime dust collector is a commonly used auxiliary equipment in quicklime production line. It is used for deferred purification, dust control and material recycling in the lime industry, the use of quicklime dust collector is wide. Quicklime dust collector can maintain an efficient, daily maintenance is essential. ZK will tell you about the daily maintenance and overhaul of the dust collector.
1 In equipment operation, specially-assigned persons hould be set up to manage, and do a good job about running records.
2 Management personnel should be familiar with the principle, performance and use of the dust catcher, and master the methods of adjustment and maintenance.
3 Speed reducer, ash conveying device and other mechanical moving parts should be in accordance with the provisions of oiling and oil, if finding abnormal phenomenon we should exclude it.
4 Gas water separator in triple parabiose of gas storage tank should be cleaned once every 3-6. Oil mist device should always be check about oil storage situation, and timely refuel.
5 If the electromagnetic pulse valve failure, fault should be ruled out in time, the internal impurities and moisture should be promptly cleaned, the diaphragm damage should be replaced in a timely manner.
6 When using timing type ash cleaning controller, regular cleaning cycle should be determined correctly, otherwise it should be adjusted in a timely manner, using constant pressure cleaning controller, the switch should periodically check about pressure, if the pressure port is jammed, clean it up.
7 Check the seal on the manhole, if there is damage or aging, it should be replaced.
8 Measure process parameters regularly, such as volume, temperature, concentration, if it is abnormal, we should find out the reasons and timely treat.
9 Check the gas system regularly, ash handling system, if is abnormal, it should be discharged in a timely manner.
10 When boot, we should first connect the compressed air to the storage tank, connect the power supply controller, start the ash discharging device.
11 When shutdown, after the process stopping, we should keep the quicklime dust collector and the exhaust fan to continue working for a period of time to remove moisture and dust in the equipment, it is important to note that the dust collector stops working, we must repeat to clean the dust remover(can by manual cleaning) to get rid of dust from filter bag to prevent damp and paste bag.
12 When stopping working, do not cut off the compressed air supply, especially in the wind turbine working, you must provide compressed air to the valve cylinder to ensure that the valve is in the open state.
13 Ash discharge device can not stop working when quicklime dust collector in normal operation, otherwise the funnel ash overflows into the bag room to force the dust collector to stop working.
Hope that the above methods can help you, if there is any problem about when you are in the process of using the quicklime dust collector, you can contact us in time!

Message

InquiryYou can get the price list and we will contact you within one business day!

Name:*
Country:
E-mail:*
Cellphone:
Capacity:*
Raw Material:
Message:*
WhatsApp
+86 18037866379
WeChat
+86 18037866379

Contact Us